could you make 3d printed screws to i could 3d print this
Iron Man MK5 Helmet with Voice Module
Conecta el módulo de voz al Arduino como sigue:
RX del módulo → Pin 2 del Arduino.
TX del módulo → Pin 3 del Arduino.
605
787
0
12 k
updated May 24, 2025
Makes
Comments
@31jo31_2799488 I don't recommend using 3D-printed screws, but if you do, just place them in fixed locations to hold the servos and not much else. I'll try to create some screws in the next few days.
I wish i didnt need to construct, it took ages could someone make a remix of this or even the creator to solve my problem?
:3
View 2 more comments
@uawuauwa_3283790
is there one without electronics <3
@Cheese_2520875 I think there are some MK3 helmets with magnets on Cults3D.