Aquara Light Sensor Vertical Mount / Stand with Magnets

I like the original from lazyslacker (credits go to him), but I didn't want to stick my sensor to the mount with the double sided tape.

So I added 2 holes for magnets (8mm diameter, 1.8 - 2mm height).
The Aqara sensor already has two magnets installed, so it holds perfectly in the stand.
I also created a little more wiggle room for the sensor.

Printsettings are the same as for the original Model:

• Nozzle - 0.4 mm
• Material - PLA
• Layer Height - 0.2 mm
• Infill - 20% Gyroid
• 2 walls, 2 top layers, 2 bottom layers
• Brim - No
• Supports - No

Thanks to lazyslacker for the model!

Added holes for Magnets.