Beatsaber / Groovylab hilt for PICO 4 Ultra

Print as is ( i use .28 resolution and 3 walls with 35% lines infill) and mirror for left holder, use a little bit of masking tape or electrical tape inside the receptacle. 

• Be sure that you are using the correct handle for each controller
• When inserting the controller always pull the strap from the bottom hole until both the pico "charms" are outside. only then ten you can push the controller inside to realize a snug fit.
• Remember to use some duct tape (but pay attention when you stop playing  to remove it before leaves glue residues) to secure the controller in place, due to the shape of the controller it was not possible to lock it in place mechanically.

Look at the picture to better understand

Disclaimer

This custom Beat Saber handle for the Pico 4 was designed and created for personal use and enjoyment. By using this product, you acknowledge and agree to the following:

• This is a fan-made accessory provided as-is, with no guarantees or warranties, expressed or implied.
• I will not be responsible for any damage to your Pico 4 headset, controllers, property, or personal injury that may occur through the use or misuse of this product.
• It is mandatory to carefully follow all assembly instructions and to wear the wrist strap at all times during use to reduce the risk of damage or injury.
• It is also mandatory to use a piece of duct tape (or "American tape" in Europe) to secure the handle to the controller.
• Users assume full responsibility for ensuring their own safety and the safety of their surroundings while using this accessory.

Use at your own risk

controller receptacle has been created from GmoLargey holders and reduced to 97% for a tighter fit and ported to my rifle holder, handle has been created from malaru one. All parts have been combined in a sigle STL