Two Cute Pandas - Coaster

No MMU/AMS required, only a single colour swap which can be done manually!

To clear any stringing (often inevitable on these 0.08 height prints, especially with wetter filament), just quickly go over the model with a lighter or hot air gun.

Diameter: 100 mm.

0.08 layer height and 100% infill strongly recommended!

For BambuLabs printers, the 3mf contains an AMS swap, in all other cases:

• Start with Black filament
• On layer 14 (height 1.2mm) swap filament to White

All my coasters use the same height swap, so you can easily print multiple on the same plate and only swap once!