Self watering plant pot

A plant pot that uses a wick to draw up water and keep soil moisture consistent and constant

Will require a wick, I designed it to fit an oil lamp wick 2cmx1mm threaded through the slots in the bottom of the top section and does need to be long enough to reach the reservoir below.

Top section requires some support for the rim to print properly. I recommend a layer height of 0.2mm and to infill by 100% they are designed thin enough to not waste filament by doing this. not doing this may cause water to leach into pockets.

I also recommend printing in PETG but will work in PLA but might break down over time from the sun exposure.