Trail tool grip

Dear Trail Diggers!

I used those grip all 2024 season on my Rogue and my 5' long prybar. It is easier to keep your muddy tool in your hand without effort, then you have more energy to smash the terrain in your day.

I printed in TPU 90 at 0.25mm. 1 piece is enough to go around. If you wish use 2 pieces, the shoulder is designer to easy the soldering process with a soldering iron.

Don't waste your time trying to use any glue, even 3M in spray can, even hot glue. It won't stick for the hole summer.

Installation procedure:

• Use sandpaper grip 80 on the shaft
• Clean with soapy water & dry
• Apply 5min-Epoxy on the shaft
• Stick the piece at the desired angle
• IMPORTANT: Apply duct tape over to make sure it sticks as wished.
• Remove tape
• Get out and change the world one hit at the time!

The only downside with the version 1.6: you NEED thin gloves to use the tool now. The version 1.5 is less sharp. I strongly recommend the version 1.6.

There is no need to do a clean print.

Prusa mini+

0.6mm nozzle

0.3mm

5mm³/sec

nozzle 235°C

bed: 52°C

1 wall

5% infill (just to save 2g…)

TPU90: https://www.amazon.ca/-/fr/dp/B074DV9JMX?ref=ppx_yo2ov_dt_b_fed_asin_title