GPU support_remix_@DiPT

I printed the model in PCCF prusament, it looks great, I recommend PetG or a more temperature-resistant material than PLA for printing, I do not recommend PLA

Print PCCF

0,2mm structural

20% infill

other settings: prusaslicer default settings

when printing a screw, prusa slicer reports low adhesion to the substrate, my test prints stick perfectly to the grainy substrate, if your models are falling off, consider adding a brim

I noticed some of the printed models had falling bridges on the printout, Prusa Slicer confirmed this, so I filled in the problem areas of the model and created a full design.

The dimensions are the same as the original, I just chamfered the edges of the 70mm screw