Direct drive mount for the printer CR-6 SE

I created my own version of the direct drive mount for the printer CR-6 SE, using the cr10 extruder.
To mount the 5015 cooler, I cut an m5 thread in the cooler hole and used an m5x20 screw.
The original motor must be installed using a slight force, bending the wall of the board mounting.
In the photo there is an older version of the mount model, I load a modified one - the cooler mount has been improved, an ear has been added for attaching the wires with a cable tie.

To use, you need to extend the wires to the heating element and the temperature sensor

This project became the prototype for my attachment:
https://www.thingiverse.com/thing:4701896

I used a nozzle from this project to cool the printed model:
https://www.thingiverse.com/thing:2551774