Rod holder for Work Sharp Precision Adjust Professional (PAJ PRO)

Holds the rod directly, so that you can use third party stone holders without needing three hands.

It replaces the original stone-holder holder plastic part, which is clipped on, just like this replacement part.

I printed the part with Esun PETG on a 0.6 nozzle, without supports.

If you use the Hapstone stone holder, be mindful of the screw head colliding with the PAJ PRO angle adjustment knob. I recommend switching it out with a headless screw, or cut the original screws head of, and make a slot in the remainder (it should be easy, as it is made of plastic).

I also recommend getting hold of a fairly long M4 screw to replace the rod end stopper screw. Otherwise your travel will be quite limited. 40 - 50mm are probably good. I have only tested with a 30mm screw.
Alternatively, remove the stopper screw completely.

The sharpener: https://worksharptools.com/products/professional-precision-adjust-knife-sharpener
Hapstone stone holderr: https://hapstone.eu/en-eu/collections/upgrades/products/universal-stone-holders-for-professional-precision-adjust