Simple USB Port for Voron Trident Skirt

This is a simple mount for a cheap 1.5ft USB extension cable. The mount is secured on the back side of the skirt using two short pieces of filament. Similarly, the connector on the extension cable is retained using two short pieces of filament. Here is a photograph showing the assembly from the back side of the skirt with yellow filament for clarity.

The two filament pieces in the back that secure the connector run vertically. While the fit is pretty tight, I recommend heating up the top of the filament and pushing it against a flat surface to make a couple of makeshift filament nails as shown below. This way, they cannot fall out but are still easy to remove.

I used the standard Voron settings to print this.