Shelly DIN mount Plus/Gen3/Gen4

Shelly Plus, Gen3 and Gen4 compatible DIN rail mount.

Easy to Print – Prints cleanly without supports
Effortless Installation – Snaps onto the DIN rail smoothly.
Quick to Remove – Comes off just as easily when needed.
Compatible with Shelly Add-on Module
print mirrored for lora add-on so the antenna is on the outside
Slim 1 DIN Width – Takes up minimal space in the electrical panel.
Low-Profile Design – Fits neatly under the panel cover, staying out of sight.

Note! This model is not compatible with a 0-1/10v gen3 dimmer.

A practical, space-saving mount — easy to use and blends seamlessly into your setup.

3D printing settings

• 0.4mm nozzle
• 3-4 walls
• 6-10 top/bottom layers
• do not place z-seams in areas subject to bending.
• print the piece on its side with the largest flat surface against the bed.