Philips Series 3000 beard trimmer station V2

UPDATE 2025-7-17: 

Fix the upper cord clip so that it doesn't need support.(Yay less support to print)

UPDATE 2025-7-16:

Found out that the little trimmer blade tend to fall after a few insertion. A easy fix is to put 2 small piece of filament in the hole of the bottom clip like in the picture. Also made a model to fix this (I hope :)).

If I missed something, feel free to tell me.

UPDATE 2025-05-14:

Upgrade from my old version.

Improve holding clip and use less support. Added space to help put accessories on.

In Orcaslicer, I used snug support with  .28 top z distance, .22 bottom z distance 3 wall loop and 15% cross hatch infill.

Mise a jour de mon ancienne version

Amélioré les support de pièces et utilise moins de supports d'impressions.

Dans Orcaslicer, j'utilise les paramètre mentionné plus haut en anglais.

Hold your Philips Series 3000 beard trimmer stuff together.

Can also hold the trimmer while charging, Just pass the wire in the groove.

With a dab of hot glue from the bottom hole, the charger plug can be permanent, I did not do it, but it can be done. 

Supporte la tondeuse Philips Series 3000 et les accessoires.

La tondeuse peut être insérer dans la base pendant la charge.

Il y a possibilité de mettre une goutte de colle chaude dans le trou du dessous pour une installation permanente du fils. Je ne l'ai pas fait mais l'option est disponible.