Skewer But Long (Full Length Skewer)

The Skewer But Long is a remix of the Charamile Designs Skewer that uses full length nerf darts instead of half length darts.

There are two ways you can use these files:

1. Print all of them, then use the standard skewer file set for the rest of the parts. Do this if you want the smallest full length skewer possible.
2. Print only the magwell and dart guide, then use Sillybutt's Harpoon remix for the rest of the parts. Do this if you want to use a Caliburn ram or Caliburn springs.

The only hardware differences between the different versions are as follows:

Assembly and print instructions are the same as the original Skewer.

Some tips on the printed ram:

• Print it vertically.
• Use a brim. It will fall over otherwise.
• Use a fine layer height (0.1mm or finer). If you have a 0.2mm or 0.25mm nozzle, use that.
• No, it will not break. I use printed rams in almost all of my blasters, and they've endured lots of gameplay and many jams with no breakage.

Licensing

This model is licensed under the Creative Commons - Attribution - Noncommercial - Share Alike license. Contact Taffy if you want to sell hardware or prints for this model.

Extended the magwell and draw length to support full length darts.