Minisforum V3 Clip Case

This is my case design for a Minisforum V3 Tablet, designed to be printable on my Creality K1C's 235x235 print bed. 

You'll need to print: 
2 back plates
2 frames
4 feet 
2 clips

The back plates need to be glued to the frames, I used super glue and started with letting a corner dry, then the short edge, then the others one at a time, being careful to keep it aligned before it sets.

I added some guides on the back plates for aligning the clips and feet, but they aren't perfect, so I put them in the “versions” folder if you want to try them out.  There's also solid models of the tablet - with and without keyboard slots - so you can chop it up as you please for your own printer sizes.  I cut the release version to minimize supports due to MANY failed prints.

I've only printed this in PLA so far, but I expect once the tablet gets warm there might be some deformation.

DISCLAIMER
You are solely responsible for the safety of your device.  I do not guarantee that this case will protect your device from a fall, bump, toss, or even a low-speed collision with a feather.  It is absolutely not waterproof, nor is it edible.  Do not leave in the presence of children - that tablet is expensive!!!