Millennium Succculum

Bring balance to the Force and your windowsill with the Millennium Succculum — a 3D-printed succulent pot inspired by the legendary starship itself. This compact freighter-turned-planter is perfect for housing your bravest little botanicals, from hardy Echeveria to cheeky cacti.

• Detailed outer hull design with iconic cockpit and engines
• Built-in drainage holes to keep your plant from going to the Dark Side
• Fits perfectly on desks, windowsills, or moisture farms

Whether you're a Rebel, a smuggler, or a humble plant parent, this is the ship that grows with you.

🖨 Print Tips

For best results, print the Millennium Succculum upright, just like the original orientation of the model — no external supports needed.

Only enable supports inside the plant cavity, where slight overhangs may occur. This keeps the exterior clean and detailed, with minimal post-processing required.

PLA or PETG recommended. Print at 0.16–0.20 mm layer height for best detail.

This version of the Filennium Malcon was modified into a fully functional plant pot:

• Top section opened to allow space for soil and small succulents.
• Drainage holes added at the bottom for water flow.
• Interior simplified to make it easier to print and plant in.
• Wall thickness increased to ensure durability.