Lenovo Legion Go Thumb Sticks - Various Sizes

I searched high and wide for a replacement stick for my Lenovo Legion Go that was both easy to print with minimal Supports and comfortable to use. While there are some decent options already out there, they weren't really what I was looking for.  

These are designed to be printed top-side down and should not require any support materials or brims to print! I have included multiple heights from the absolute bare minimum 9.215 mm up to 15 mm. Need a different size or configuration? Please reach out to me!

While this has not been tested on any other devices, this may work for others! Please tell me if you find another these work with! For convenience, here are the inner dimensions:

• Pad Diameter: 18 mm
• Hole Diameter: 5.6 mm
• Hole Dimensions (flat-to-flat): 4.6 mm
• Depth: 5 mm

Printing

• PLA preferred. PETG may work but will not be as grippy.
• Parameters
  • 0.4mm nozzle
  • 0.1mm layers (the finer the better)
  • 3 Perimeters
  • 15-20% Gyroid infill
  • No Supports or brim needed!
• Orientation: Up-side down with hole facing upwards.

Absolutely no commercial use!