JetKVM Magnetic Feet Case

A quick remix I created in Tinkercad from the original "JetKVM case - magnetic feet".

This remix adds an additional circular insert for 8mm x 3mm magnets. The magnets I used for this model are located here at this Amazon link: (Amazon USA) 40pcs 8x3mm Small Round Refrigerator Magnets

I also cleaned up the original model and removed various micro gaps and inconsistencies with the symmetry and overall appearance.

Suggested Print Settings: 

This model takes very little filament to print (~27g)

• PETG/Temperature Resistant Material
  Could be printed using PLA or similar material,  but if using inside of a computer case or hot location, PETG or other similar temperature resistant material is suggested.
• All/Maximum Perimeters
  Selecting around 6 perimeters in your slicer should work fine, the goal is that this model should be printed entirely of perimeters with no infill, for maximum strength.
• No Infill
• Supports Enabled - Organic/Tree
• 0.2mm - 0.15 Layer Height

Added: 

• Additional insert for magnets

Modified:

• Resized inserts to fit 8mm x 3mm circular magnets

Removed:

• Minor imperfections and gaps located in original model