Hinge for 2020 profile with acrylic sheets

I needed hinges for a laser cutter enclosure I was designing but could not find any model that can attach to the profile where an acrylic sheet also sits. Because my command of meshes in Fusion360 is rather limited, this modification is very crude, but fits properly.

The indentation is intended to allow for 3mm thick acrylic sheet to be pressed in place by the hinge - on one of the sides. 

To mount each hinge you need four 10mm and four 8mm M4 countersink screws.

If you need shorter hinges, just cut the model in the middle in the slicer.

Split and shifted one side of the hinge to accommodate an acrylic sheet laying on the extrusions.