Lightsaber Holder v2

This is an upright stand for a lightsaber prop. The inside is measured out to 34mm, which should be large enough for most grips. If your grip is larger or smaller, you can resize the part to be the correct width and height based on what you are wanting to display in it.

On the mini+, this will need to be printed in 2 parts, where the top part (without the crossed base) will probably need to be printed at a slower speed. At 50% speed (with Input Shaping enabled) the part printed fine.

This was printed in PETG, which is my preferred material, but PLA should work fine as well.