Hex Wrench Holder Imperial, from 0.05" to 1/4"

Here is a hex wrench holder for imperial wrenches. It covers wrenches from 0.05" (the smallest) to 1/4". It contains the following features:

• Two rows, to allow holding two of each wrench should one get worn down.
• Measurements above each holder that tell the measurement in the most common format (i.e. ¼") as well as a smaller one that tells the measurement in 1/64'ths.
• Printable in one piece with no supports.
• The base is thick enough so that the wrenches do not bend while in the holder.
• Each holder was carefully measured so that a smaller imperial wrench does not fit. However you are recommended to size your wrenches with calipers to make sure you have the proper size (and not a metric one). Please see the PDF/CSV for the measurements.
• Each holder is a hexagon shape, not a circle.
• The following wrenches are covered here: 
• 0.05", 2/32", 5/64", 3/32", 7/64", 1/8", 9/64", 5/32", 3/16", 7/32", ¼"
• The secondary names included are:
• 0.05", 4/64", 5/64", 6/64", 7/64", 8/64", 9/64", 10/64", 12/64", 14/64", 16/64"
• STL and FreeCAD source files included.

The photo is printed in 15% infill with a 0.2mm Quality setting on PrusaSlicer for the MK3 i3. Print time is around 5 hours.