Civil Disobedience Earring or Keychain Set

The brick prints at 4cm long and the bottle at 4cm tall.  You can make them a bit larger if you want but I would not suggest printing smaller.  These are pretty light and comfortable to wear.

You probably would want to print them scaled up a bit if you are going to use for a keychain. 

The bottle is hollow.  The brick has a hole cut out for a jump ring.  A jump ring with a diameter of 8mm fits snugging.  A 10mm jump ring also works well.

The brick does not need any supports or brim. 
The Molotov cocktail should be printed with a brim.
Parts:
 

• 1x Bread tie (twist tie) *you can also experiment with other things but these work really well.
• 2x jump rings (8-10mm in diameter)
• 2x earring hooks
• 1x eyelet screws/pins/hooks (multiple names)
• Jewelry glue (E600 does the job, a two part epoxy is even better.  Avoid super glue and hot glue)
   

Assembly:
1. Bend the bread tie in half and twist. 
2. add glue to the end of the bread tie that is connected.

3. add glue to the opening in the bottle.

4. put the connected end of the bread tie into the bottle opening as far as it goes. 

5. push the eyelet screw into the hole and rotate to screw in.  

6. bend bread tie to be aesthetic and trim.

7. optional:  add a little black paint to the end of the bread tie and shake a little red glitter on it to make it appear on fire.  
   optional: use a sharpie to draw 3 Xs on white cardstock and glue to the bottle

8. Let everything dry for a few hours (E600 dries slowly when there is limited airflow, let it sit overnight).

9. attach jump rings (bend sideways when opening, do not pull jump rings open from center). 

10. attach earring hooks or keychain ring. 

Tip: make sure there is sufficient glue to bind everything. Use the bread tie or a toothpick to push glue into the bottle opening if needed.

----------------------------------------------------------

This model is 100% my own and I give the following permissions:
You can:
Sell printed models (online or locally)
Create remix versions with attribution

Please don't:
Sell the model files
Claim the model as your own

Filament used:
Bambu Red Brick
Bambu Metallic Green