Bike Lock holder-Mount for OnGuard Lock

The original bike lock did not fit my bike so I designed a new one. I'm using the original mechanism to secure the bike. 

Printing Parameters:
4 walls and 30% grid in-fill with PLA as it was already loaded. I will see how long it last and potentially reprint in ABS. 

IMPORTANT: print on the side for maximum strength (check the side that uses the least supports. Enable supports on plate only.

The bike BTWIN (from decathlon) has the brake cable running through the tube so I had made a notch on the model so that the wire fits nicely in there.

Update version v5: 

• Increased the diameter of the holder by 1mm so you can use a piece of tire tube in between. 
• Adjusted the nut size to make it more tight. 
• Adjusted the groove for the bike brake that is running along side the tube.
• I have not printed this version yet but should be better than the previous version