Figurine base: Ayanami Rei in ballet outfit - seated

A figurine base for this figure.

Ayanami Rei in ballet outfit (seated). There is a cut-out for her foot and hand to go down and not scrape the base. Yes, the elevated foot does not fit perfectly. Organic modeling is hard. I'm sorry.

The base is printed top down. The pins are printed sideways so it will not fail if you have to remove it from her. You may need support on the foot part, but if you want to YOLO it, risking the tip of the pin stuck inside her foot on remove, then sure. I'd recommend PETG because it has better layer adhesion than PLA. If you're using PLA, however, sideway print is recommended. I don't want you to damage her trying to ply a piece of PLA out of the sockets.

Yes, she actually has a ballet skirt but since I couldn't even do the foot elevation right, ballet skirt is just on another level. I will try my best to do it, and will add here later if I manage to.