Impossible Fidget Spiral toy (FREE TO SELL)

Impossible Fidget Cone!

There's 2 print profiles. One where both parts are on the same plate, and the other includes 1 part on each plate if you would like to use several colors or just want to print separately. The lower layer height, the less friction there will be when passing through. 0.08mm layer height is recommended

If you have adhesion issues, run full bed leveling and make sure to wash your bed with dish soap and warm water!

Feel free to upscale this. It can be downscaled too, but take caution as downscaling/upscaling will affect tolerances.

This is free to sell, enjoy!

Makerworld listing