Chevy Bolt Key Fob Slot Phone Mount (Magnetic)

This mount provides a secure and convenient way to keep your phone visible and accessible while driving your Chevy Bolt EV or EUV (tested/designed for [2022-2023 maybe others i only have a 2022 and 2023], please confirm fitment for your specific year).

It slides firmly into the key fob holder slot, offering a much more integrated and stable solution compared to universal mounts. The design features a sturdy post and a flat circular platform ready for you to attach your preferred magnetic phone holding solution.

Features:

• Custom Fit: Designed specifically for the Chevy Bolt key fob slot for a secure, non-damaging installation.
• Optimal Viewing Angle: Positions your phone conveniently for navigation without blocking critical dashboard elements or vents.
• Clean Installation: No messy adhesives on your dash, no suction cup rings, no blocked vents.
• Magnetic Ready: The flat circular top (Diameter: [66mm) is perfect for attaching an adhesive-backed MagSafe puck/charger holder or a standard magnetic mount metal plate pad (like those from Scosche, QuadLock Magnetic, etc.).

Required Hardware (Not Included):

• 1 x 66 mm disc magnet. (https://www.amazon.com/dp/B0CYZNNWM4?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1)

Assembly & Installation:

1. Print: Print the mount using the recommended settings below.
2. Prepare Mount: Clean the circular top surface of the print thoroughly.
3. Attach Magnet Pad: Firmly press your chosen adhesive magnetic puck/pad into the circular platform. Allow adhesive to cure if recommended by the manufacturer.
4. Install in Car: Carefully slide the base of the printed mount into the key fob slot in your Chevy Bolt's center console until it feels secure and snug.
5. Mount Phone: Attach your MagSafe-compatible phone or phone with a metal plate/magnetic case to the mount.

Printing Recommendations:

• Material: PETG or ASA is highly recommended due to higher temperature resistance inside a car. PLA may warp or deform in hot conditions.
• Layer Height: 0.2mm
• Infill: 15-25% (Honeycomb or Gyroid recommended)
• Supports: none needed
• Orientation: Print standing upright (as shown in the photo) for maximum strength in the vertical post.

Notes & Disclaimers:

• Please verify the fit in your specific Chevy Bolt model year's key fob slot before permanently attaching adhesive pads. Minor variations might exist.
• The strength and stability depend on print quality and the chosen magnetic mounting pad.
• Always use your phone responsibly and in accordance with local laws while driving. The primary use should be for navigation or hands-free communication.
• The designer is not liable for any damage to your vehicle, phone, or magnetic accessories resulting from the use of this mount. Print and use at your own risk.