Semifixed LowCost Enclosure Remix Remix

Remix of the Lo Cost enclosure.  Added back panel.

I printed with PETG with no issues, other than the gaps from the original parts.

I modified the original parts using modifiers in ORCA slicer.  If interested, I could spend a few minutes and just use the original DXF's to correct the panels from the original.

I recommend printing with standard .20 layers, but do all the edges vertically, to minimize the use of supports.  I printed an original with supports and ended up wasting almost a whole spool of fimament before I realized that it would take me hours to get the support out and the leftovers would still block the panels and make it not fit.

I found some of the panels were too small, leaving large gaps.  I adjusted the vertical connectors to be wide enough to cover the gaps.  This was the “quickest” fix, since I had already used 3 spools on this.  I could fix it from the original DXF's if you like and want the correct sized panels.  I also added the missing back panels - they printed the correct size with no gaps.