IKEA Skydrag 300mm mount for Original Prusa Enclosure

The 300mm length version of the IKEA Skydrag was on sale, so I bought a bunch of them. This is a very simple model which slides onto the end of the original mounts and then screws perfectly into the mount holes on any vertex of the Original Prusa Enclosure. You'll need 2 m3 hex nuts and a couple of m3 screws.

I also created a compact cable clip, small enough to attach beside the LED strip when installed so you can run cables neatly. This also uses an m3 hex nut and m3 screw.

No supports needed. 0.2 layer height is fine. I used PETG but PLA is probably fine too.