Find-R-Scope AA Battery Adaptor

This is an upgrade for an older model of the FJW Find-R-Scope (lets you see IR and UV).  

It used a battery that's not easily available (mercury type).  The manufacturer has also made AA and C adapters, but the cost seems high.

This is printed in two pieces without supports.  Copper braid is held in place by a pressed in metal sleeve (I used some left-over tube).  The braid crosses under the end cap to contact the positive end of the AA.  You could probably use some thin un-insulated copper wire for that.

End cap is glued on to the threaded part with E6000.

The function of the spring is to keep pressure against the high-voltage circuit container inside the handle, so it has good contact.

Printed in PLA with 01mm layers.  No supports.

Designed in FreeCad.