19.8 mm tube holder

Behold: the 19.8mm Tube Holder of Slight Decline™ — engineered for one simple yet heroic purpose… to hold a tube on a garden gazebo at a precise-enough angle to let water drip off like a well-trained bonsai waterfall.

Because let’s be honest — sometimes you don’t need high-tech smart irrigation. Sometimes you just need gravity, a zip tie, and a 3D print that doesn’t explode at 50°C.

📏 Designed for a 19.8mm tube (yes, actual 19.8mm, not “20mm-but-actually-19.3” like some printers think).
🎯 Mounted to a gazebo frame because apparently I like building garden infrastructure that looks like it was designed by IKEA and printed by NASA.
📉 Added a gentle slope for drainage — because flat tubes are sad tubes, and standing water is where mosquitoes party. Not on my watch.

Printed in whatever filament was closest to the printer when inspiration struck. Still holding up, despite direct sunlight, wind, and whatever weird tension physics is going on up there.

Files available for remixing, scaling, or turning into a lightsaber hilt.
Let the water flow, and may your prints never warp.