9g Servo Glue-On Mount with Wire Guide

UPDATE: I realized that I had forgotten to extrude a cut in the side of the mount for the servo wire. I just added that. I need to print a few of these for myself today, so I'll see how it goes. At some point it cut be cut up with lightening holes to reduce the weight and not compromise strength. I may do that later. Maybe it needs to be lengthened on the end where the wire guide is. I'll update it again if it needs more work! 12/19/2020

I couldn't find a 9g servo glue-on mount for my Eclipson Z, so this is what I came up with. I hope it works for you!

I know it adds a little bit of weight, but with these, you can place the servo anywhere you like and firmly attach the mount.

Print Settings

Printer:

Sovol SV03

Rafts:

No

No

Resolution:

0.20

None

Filament: Generic PLA PLA Black