Servo Holder Fuselage - Eclipson Panthera V2

Edit: (12/27/21)
Turns out the holes are slightly lower than I wanted them to be. I'll have to remake the part to fix the hole placement. I accidentally deleted too many of the points and lines in the stl file in Fusion 360 to be able to just go back in the timeline and fix it. The screws will still go in, it's just that the hole placement isn't perfect, like it is on the wing servo holder that I made.

12/26/21
Sometimes saving weight comes at too much of a cost, when parts are just too flimsy to work. I'm not saying the original servo holders don't work, but I can barely print something that thin, and be able to put screws into it, and (1) have the screws hold well, and (2) not have the screws break the part.
When I put the wing servo holders into the wing, the servos had already broken free of their respective mounts. I hadn't realized that the screws cracked the mounts, even thought the screws were 2mm in diameter - just the right size.
So I print these in PETG, and so far, have had great success with them.

Print Settings

Printer:

Sovol SV03

Rafts:

No

No

Resolution:

.20mm

100

Filament: Generic PETG White

Notes:

Print at a scale appropriate for the material you are using.
PETG has a shrink rate of probably 1-2%, so scale the part up by that amount.