Ace Pro Silica Container

Made it so the different pieces are distributed evenly over the filament feeders

Didnt bother about openings for the leds, I can see them just fine since i used transparent PETG.

The irony: had some stringing in the openings due to not perfectly dried filament, but not much actually. Ok for these functional parts.

Made the base and container as separate parts to avoid to much supports, glued them afterwards

Standard preset for 0,2mm. But the Temperature at 250°C

Notes:

• container-small-corner-L needs to be mirrored in the Slicer!
• total 1big, 2 smalls, 2 mids (each), 2 spacers a+b