Water Pressure Gauge Adapter - Mercury Marine

I ordered a small water pressure gauge for my Mercury / Mariner 150 outboard motor, and plan to mount the gauge in the back of the boat. When the gauge arrived, there was no way to mount it.
The gauge sits nicely in this adapter (printed at 103% size due to PLA shrinkage).
You could put a little silicone in the bottom of the adapter to hold the gauge in tightly, or just zip tie the 1/8" hose coming off of the gauge, and it probably wouldn't ever move.
Printed in Cura, but should print very well in any Slicer.
I did not use supports when printing, and I probably should have, but I struggle to remove them after printing. I would print it with either round face on the print bed.

Print Settings

Printer:

Sovol SV03

Rafts:

No

No

Resolution:

200

100

Filament: Generic PLA Blue