Modular Cat House

Welcome to your cat's new favorite place to relax! 

This cat house uses an ESP32 Camera module with Arduino so you can check up on your cat from anywhere! The initial design was inspired by the Cat Kneading bread meme. But then I realized if I made the design modular, anyone could decorate it however they wanted. Using a ESP32 board you can connect a camera to wifi or bluetooth. The parts can all be printed using a 210 x 210 mm print bed like the Prusa Mk3s. The hardware used is M3 screws and heat inserts.

The feet are designed to be printed in TPU to prevent slipping on smooth floors.

There house is designed to be compatible with an automatic cat blanket. These heated pads are every cats favorite. The one I used is waterproof, and high-quality. I used this one: https://a.co/d/dF3iW7d

This is the ESP32 Camera module I used: https://a.co/d/dF3iW7d

This tutorial page is what I used for the ESP32 Camera module: https://freenove.com/fnk0085

Warning: This is a large print, around 2 kgs of filament, and requires a lot of printing time.

Special thanks to Ellie, Renee, Erika and Bayley