Bee Hotel

A simple Bee Hotel made of two parts:

• Inner housing to fit in tubes and other elements
• Outer body for decoration

I made this model to replace my old bee hotels which were old and rough weather broke them apart, so I moved some tubes and added new tubes as well.

It's easy to print, no supports needed.

You can use adaptive cubic infil to save a bit of filament.

I used Overture Brown and Black Petg to print both variants, with 0.20 layer height.

To hold both parts, I added inner hole for a small screw.

Note: on the Bamboo outer body printed results you may see I have a few layers of different colours - I did it intentionally because brown filament was at the limit to finish before the print is over.