Effect parts for HG 1/144 Pharact

Parts that allow you to reproduce the laser line effect seen by the Pharact in The Witch From Mercury. 

These are push fit parts that do not require any extra adhesive.

Simply print a male and female part (the male is likely to need supports unless you are incredibly confident in your printers ability to do overhangs). Once you have the parts they should fit nicely onto their corresponding half of the gund-bit (included in HG Gundam Pharact, not part of this model). Then cut some runner and put it in the holes on each part.In the photos no glue has been used to keep the runner in place, however depending on the size of your runner, it might be a good idea to add a small drop to keep it secured in each hole.