Worx Landroid Robot S500 i Upgrade 2. Back Wheels 2.4 Tire 70mm / FINAL

This is the final version 2.4 Tire So why, my be love robot slipped all the time when he drove over certain plates in the garden. The reason why he did that was, cause the friction of PLA to low. So I printed the tire in TPU. It was / is great. But wasting so much TPU for a tire mmmh.

So I designed a more save the planet tire.

Here are the instroction

1 --> PLA --> print the Rim (didn´t change you are able to use the old one) 2 --> PLA --> Tire holder (new) 3 --> TPU --> SPIKEs -->36 times (print setup wall 6 times and infill high)

Worx Landroid Robot S500 i Upgrade Type of the Robot WM105_Si

The mega Upgrade

1. Front Spoiler
2. Back Wheels 2.1 RIM 2.2 Tire 41mm 2.3 Tire 70mm / Diffrent veriations ------->>> 2.4 FINAL TIRE most improved
3. Blade 3 times
4. Front wheel

Have Fun, don´t hesitate to give a like or post a make picture. Open for any improvement ideas.- just send me a message.

Additional Informations------

Fits also for Ferrex R800 Smart from Aldi.