TR6 Blade Fuse Block Mounting Plate

A small adaptor plate to allow an off the shelf 4 way MTA fuse block to mount to the existing mounting points in the TR6 engine bay. It should also work for any car that uses the Lucas 7FJ 4 way (glass) fuse box.

Replaces the old Lucas 4 way glass fuse holder. All the contacts on mine were very loose, and was causing fuses to arc and blow on the move. This is a cheaper and alternative to a new Lucas style fuse box - and blade fuses are found everywhere.

Easy to print. Print flat side down and the only supports required are for the two main countersunk mounting holes.

Once printed, two M5 threaded inserts are installed into the non countersunk holes.

To install, remove the old fuse holder and screw the plate onto the bodywork using the same screws you removed when taking the Lucas box out. Then mount the blade holder at slight angle to allow the holes to match the threaded holes in the plate, and use M5 hardware to fix in place.