Monoprice Delta Mini 3D Printed Enclosure

My goal is to print small ABS things without issue. Mini Delta for starters, later Delta pro.

Feel free to print and enjoy as this project is complete and works on all 3 sides :D And hey, if you were blessed by this design wont you leave me a tip? ;) just use the paypal link, or better yet hire me for your next project :D https://www.we3Doit.com

JUST MAKE SURE TO PRINT WITH A SKIRT/BRIM. The topmost section is very thin on the bottom. Also*PRINT THIS LIKE 1% SMALLER BECAUSE I WAS DOING THE MPMD IN CAD AND IT TURNS OUT I MADE THIS SLIGHTLY BIGGER, WILL UPDATE IN THE NEAR FUTURE***

INSTRUCTIONS:

To print this on MPMD, use the files half 1 and and half 2. They have 4 pieces each, to print a single side of the enclosure.

ULTIMATE is a 1 piece print, the entire wall.

Custom Section