MP Delta Pro Spool Holder/Spinner V4 Upgrade
Description
PDFNOT FOR BEGINNERS (unless you don’t use the bearings)
Must have a perfectly clean bed and perfect settings for this to work right. 0.2mm clearances on the bearings.
Simplified yet improved version of my spool spinner. This is the V4. It works with HATCHBOX spools which have a 55mm diameter center hole. The fit clears by 0.4mm.
Printed in 4 Parts, then assembled in 5 seconds. The bottom bearing has a spacer to go over the plastic clip to prevent interference with bearing.
POST PRINTING: (FIXED!) The main piece is an exact fit and therefore tight. Ill update it later to give it some wiggle room. (FIXED!)
UPDATE 1: Added clearance for easier fit. Simplified even further by making 3 structural points instead of 4 and separating the main body into 2 pieces for faster printing and ease of use. Left an updated 1-piece spool spinner in case someone likes it better that way ;)
we3Doit.com
Custom Section
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
