Batman 13 Head - Dummy 13 v1.0 Head Variant

This is a fully compatible replacement for a Dummy 13 v1.0 head. The head snaps into the frame and stays in place with no adjustments required. Just be sure to match the scale of your Dummy 13 v1.0 sliced file. 

I used this to spice up my son's Dummy 13 I printed him and he loved it. 

The file itself is far from perfect. You'll find some imperfections around the neck and ears that I was unable to fix in a reasonable time on a low end laptop in Fusion360 (mine's more like Fusion180 at best). With all this said, it still prints as is and works right away. Enjoy!

Print Instructions: printed on Ender 3 v3-SE (Cura slicer)

+ Standard printer settings will work with this file.

        Nozzle: 0.4mm

        Layer Height: I used 0.2mm (others will work)

        Infill: 15% (personal preference)

        Temperature/Material: dependent on filament recommendations

        Supports: No. Bridging will occur on inside of the model

        Build Plate Adhesion: Skirt

        Model Orientation: Print with flat part of neck on the build plate (you will have to rotate this in your slicer)

        Post-Processing: None, unless you decide to paint it

+ I used PLA for this print, however, if you're concerned about durability or other properties, this can easily be printed in PETG or ABS.

*I am not an affiliate with Batman

+ Cut: I used the Separate by Plane feature in Fusion360 to separate the head from the rest of the upper body, then deleted the upper body portion. I then made an angled cut to match the angle of a standard Dummy 13 head.

+ Scale: I used Fusion360 to overlap the Dummy 13 v1.0 model with the Batman Bust model. I changed the size of the Batman Bust file to be slightly larger than the Dummy 13 v1.0 file. 

+ Combination: I used Fusion360 to Combine the files into one Body, making sure to hollow out the head to allow for the Dummy 13 v1.0 neck frame to attach to the Batman head.