Fan duct AXP90-X47 cooler | for S300 cases

A small and simple fan duct for the X47 cooler from thermalright. made for the S300 case (i.e. Shiny snake S300 and the other names the case is sold under).

Slots in tight on the cooling fan and makes it so that hot air doesn't recirculate into the fan from inside the case. There's less than a mm of space between the duct and the sidepanel and it doesn't get in the way of the metal holding bracket.

Works with the Noctua NF-A9x14 and the stock thermalright fan without problem; For any other 92mm fan, make sure the fan cable doesn't get in the way (the middle 50mm of the sides of the fan are covered by the duct).

Check your fan height! 

14mm fan height => fan duct S300 14mm (9,8mm duct length)

15mm fan height => fan duct S300 15mm (8,8mm duct length)

PLA should be enough as it doesn't make direct contact with any hot surface.

If you're interested I can make custom duct lengths for you :)