Panda HueForge

• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
• Model size is 150 x 200 
• Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. 
• You may print at higher layer heights below the Min Depth of 0.56mm The Max Depth is 1.8mm and the Actual Depth is 1.8mm

It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.

Filaments Used:
PLA Elegoo+ Black Transmission Distance: 0.3
PLA Elegoo + White Transmission Distance: 6
This print uses 2 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to White for the rest.