(Ulanzi) AT-05 CAP
The cap that came with the product only protected the screws, so I designed a cap to protect the tip of the light stand.
0
6
0
27
updated
April 23, 2025
Description
PDFI designed a cover over the tip to avoid contact with people or other equipment when moving the light stand.
Support material settings are required when printing.
Since there is a 1/4 screw inside, a pitch of 0.15mm is recommended.
The wall is assumed to be 3.
It may also work with other similar products, but I don't have them on hand so I can't verify.
Ulanzi AT-05 https://amzn.to/4iq6mUx
Material: PLA, etc
Pitch: 0.15mm
infill: 15% or more
Wall: 3
Support: Need
Brim: Better
Tags
Model origin
The author marked this model as their own original creation.
