Mellowfly ADX1345 Input Shaping head/bed mount for neptune 4 plus

I tried out a few of the prints but none of them seemed good, and since I only had M3 4mm screws, no nuts, some zip ties and a dream to get this done just today, i decided to design this

the bed piece can be zip tied but if you want to use screws and nuts probably a m3 8mm does the trick just fine.

to place the input shaper in the mount all you need is 2 m3 4mm

it worked pretty well and i managed to do the input shaping just fine

printed in PLA, 0.2 layer height, no need for supports