Rose with Stem, Sepals, and leaf

I wanted a 3D printed rose that had the following, Quick to print, Had everything (Stem, Leaves, Sepals), And connected securely together (with a bit of super glue).

So after doing a bit of modifications to other designs and then putting it altogether, this is what I have.

Many thanks to the original designers! Please see remix section for the designs I modified.

Vase in pictures is from "SPIRAL vase" by YSoft_be3D

Print instructions

Category: Decor Print Settings

Printer: Flashforge Dreamer & Prusia I3MK2S

Rafts: Yes

Supports: No

Resolution: 200

Infill: 15-100%

Notes:

I only used the raft for the "leaf".

Infill I varied from each part.
Flower = 100%
Sepal = 15%
Stem = 75% (Probably could have just done 15%. But I like Strong Parts.....)

I used 0.010" clearance for the "Stem" to "Sepals" connection. This allows for a nice snug connection when I printed it with my printer and settings. Depending on you printer and settings this may also work for you, or not. If not, scale the "Stem" or "Sepals" or both to get the fit you want.

Flower took me 2 hr. to print.
Stem took me 1/2 hr. to print.
Sepal took me 1/4 hr. to print.
One "Leaf" took 1 hr. to print.
Your print time will vary depending on settings.

Post-Printing

If printing in PLA, simply run Sepals under hot tap water and bend to desired position. You can also use this method to but a slight bend in the stem for a more natural look.

If printing with other material you may need to use a lighter or other heat source to bend the desired material.

Simply glue all parts together.

Thanks for looking!

How I Designed This

I used Onshape to Draw up the "Stem" and "Sepals". The file is public and can be seen and modified by anyone with a free Onshape account. Access at this link. https://cad.onshape.com/documents/b4e618e89cb64a652dfbf729/w/8a49978650df175e4575aee3/e/488dba6728c7ef2225bc83f1

I did not modified the "Flower" at all. It is taken from "Stem and thorns (for anniversary rose) by MikeNeame"

Using Slic3r Prusa Edition, I scaled and cut the "leaves" from "Long Stem for "Rose with stem" by greenogre" to work with my remix design!

This is a Remix from Thingiverse following Models,

-Printable Rose Flower
by Jerrill

-Stem and thorns (for anniversary rose)
by MikeNeame

-Rose flower with sepals
by phil38

-Long Stem for "Rose with stem"
by greenogre