Makita DC18RC Single Port Rapid Charger wall mount

One stop shop for a wall mount for the DC18RC charger. 

Standoff is 12mm long(8.2mm diameter instead of 8.1mm from original) with a 3mm base to tie them all together. 
Has a 4.5mm through hole for 8G screws and a 1.5mm chamfer hole. The screw head will sit on top of the standoff. Don't over tighten, it's not needed. 

From the original template, you'll notice that the 4 holes aren't all square to each other. Just make sure you have it round the correct way when installing it. 

I printed mine is ABS but i'm sure others would suffice as well. 

I did 4 walls, 3 top and bottom and 16% infill. 

All files are uploaded and if you are after another file type, just ask. 

Changed the diameter of the original from 8.1mm to 8.2mm as the hole size is 8.25mm. It's a nice snug fit now and no need for silicone like was suggested. 
Also used the template and made all standoffs into one, so no measuring or chance of not getting them lined up incorrectly.