Mini Talon Motor Mount Remix M3x34mm

Hi,

This is motor mount for Mini Talon FPV Plane. M3 nuts are placed inside the print, maximum thickness of nut is 3mm. I used 2,3mm thick nuts, which worked fine on this project.

You can use 10mm dummy on opposite corner of printing area to able to pause printing for test fit nuts. Nuts must be even or just below surface, so that nozzle could not hit nuts.

Motor mount plate is suitable for Cross Plates which Bolt Hole Center is 34mm, like NTM Prop Drive 28 Series.

Print Settings

Printer:

CTC

Rafts:

No

No

Resolution:

0.1

50%