Soothie/Wubbanub Pacifier Cover

This is a pacifier cover to protect the business end of a Soothies pacifier from the elements while it's not in the babys mouth. It snaps over the whole rubber part, and stays on pretty well even while being jostled around.

Update 3/3/2019:
Added a loop to the cover (v11) so it can be attached to a pacifier clip, or anything else to keep it handy while not in use.

Update 5/23/2021:
Added v12 which has larger tabs and they are rounded to make it easier to pull out the pacifier and reduce sharp corners.

Print instructions

Category: Household Print Settings

Printer Brand: Anet

Printer: A8

Rafts: No

Supports: No

Resolution: .1

Infill: 0%

Filament: Shaxon PLA Red
Notes:

Used Cura 3 for slicing and it did not use any retracts, which made it nice and clean on the inside without any stringing.