Buzz Bee Hunter Short Dart Mag Well

--The models include 2 different mag wells, one that can accept only katana mags, and one that can accept both katana and talon mags. However, I do not own any talon mags yet, so the mag release is only in the correct position for Katana mags. When I get a talon mag, I'll update the models.

--The models include 2 different dart receivers, one for use with a 1/2 inches CPVC barrel, and one for use with 5/8ths inch polycarbonate tubing (https://www.amazon.com/gp/product/B000OMJ4YW/ref=ppx\_yo\_dt\_b\_asin\_title\_o03\_s00?ie=UTF8&psc=1).
A 1.5 inch long piece of either barreling material you choose will be needed.

--For the breech, the stock breech/ bolt assembly must be cut 2.48 inches from the side in which you would normally put the dart.

--The breech will require a 11mm OD, 2mm thick o-ring

--For the mag release, I used a piece of black foam as a spring.

Print Settings

Printer Brand:

MakerBot

Printer:

**Rafts:** Yes

Supports:

**Resolution:** .2 mm

Infill:

**Filament:** [ Makerbot PLA ](http://www.amazon.com/s?url=search-alias&field-keywords=Makerbot+PLA&tag=thingiverse09-20) Custom Section ==============

Dart receiver with barrel (left) that replaces and is screwed into the same place as the stock piece (right)

Dart receiver and breech installed

Mag well attached to dart receiver using screws

Category: Mechanical Toys